Hello! So, while we were putting up Christmas decorations this weekend, I ended up with extra garland. Me? no way... This mini tinsel garland was the perfect antiqued silver color and I had just purchased it at Target. I was outnumbered by the boys and told there will be NO garland on the tree. What??? Since this year is the first where the mini men have been big enough to really help decorate the tree, I gave in, after a lot of whining on my side. So yep. I'm obsessed with garland...and I have none on my tree. I'll let it slide this year. But I just couldn't bear to put this cute little tinsel in the attic. I don't have a mantel...or a staircase...hmmm...
So, supply wise, a roll of picture hanging wire (from a hardware store) and about 16 ft of tinsel. The mini tinsel works best with the thin wire. By all means use the big stuff if you want something huge, just remember to increase the gauge of the wire so it's stronger.
Before you start, lay out your word/letter/design to check that you have enough tinsel, it would be terrible if you ran out and ended up with "ho"
Use the wire cutter attached to the roll packaging or a pair of wire cutters if you have them. Cut about two foot sections of wire to start. It is easier to attach two pieces of wire together later. Also, cut a bunch of little 2 inch pieces of wire. You will use these to secure the tinsel to the wire.
Keep going until you get to the end of the piece of wire. At the end, twist a new piece of wire to join the new section and continue down the line. After you have a large length of tinsel covered wire, start forming your letters. Use the smaller "twistie" pieces to secure the letter formations and any loosened tinsel. Twist, bend, twist.